9/1/2023 0 Comments Home depot tool box![]() It does not have any markings indicating the location of the rear of the blade. ![]() The saw has a clear plastic window and some measurements allowing you to gauge where the front of the blade is for plunge cutting. This is important as we’ve seen other competitor saws cut into this strip when set to 45 degrees. Additionally, the saw blade lines up perfectly on the splinter guide track strip at both settings. ![]() We found the Ridgid Track Saw accurate out of the box at 90 and 45 degrees. The RIDGID is less powerful than both saws. I was curious how the Ridgid track saw power compared to our cordless Milwaukee and 40v Makita track saws when cutting, so we did some side-by-side cutting to compare. We especially noted that the saw struggled in thicker materials. Our testing showed that the RIDGID saw is underpowered and requires you to push harder than a more powerful saw. We made a few cuts in some scrap ¾” Purpleheart. In the shop, we tested the Ridgid track saw by cutting ¾” Ipe, Mahogany, Maple, and 1-5/8-inch Poplar, which are common hardwoods we encounter here in the Northeast. It is also a good indicator of how hard the wood will be on your tools when cutting. ![]() We often refer to the Janka test to educate clients on denting and wear and tear on hardwood flooring or wood decking. The hardness of wood is rated on an industry standard known as the Janka test, which measures the force required to embed an 11mm steel ball into the wood by half its diameter. When determining the hardness of hardwood, we often refer to the Janka scale. When testing the RDGID Track Saw for cutting power we wanted to use a hardwood that is known for its hardness. We’re ambivalent about the use of track saw variable speeds, as we typically are cutting wood or sheet stock at top speed. According to Ridgid, this saw was very specifically dialed in to not need the use of variable speed, effectively eliminating the possibility of the user forgetting to adjust the speed and ruining a cut. and does not have a variable speed dial to adjust RPM. The RIDGID 6-1/2” Track Saw weighs 8.8 lbs. I also was disappointed to see that the saw has lighter-weight plastic parts and components, such as, knobs, bevel slide, depth of plunge mechanism as well as the track adjustment knubs in the saw plate. When initially using looking over the saw I immediately noticed how strong the plunge spring was, and wondered if that would later be an issue. The Ridgid track saw comes as a kit with: Other manufacturers have batteries in awkward or hard-to-reach locations. I was impressed that Ridgid designed their cordless saw to operate on one 18-volt battery and put that battery in a good spot.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |